General & Traditional Bay Components

Traditional bays is the name SMT Designs' has given to the custom bays that people design from scratch for their rockets.  SMT Designs loves all rockets and created this category specifically for rocketeers who like creating custom bays for their rockets.  There is a point where life can be made easier by using some manfactured parts that are designed spcifically for rockets.  The typical commercial feedthrus, wiring blocks, and battery holders are general parts that are designed for a wide variety of environments. They are not designed for G acceleration, sealing air paths, and other such rocket specific problems we face when we design bays. This category has a wide range of parts that still makes the bay design custom, but makes like easier because they are designed for a rocket's enviroment with repair and upgrading in mind.

View as Grid List
Sort by
Display per page

Single Module Bay Adapter

BAM-01117
The Single Module Bay Adapter is designed to be mounted on a traditional bay sled and supply mounting for all of SMT Designs' device and battery carriers.
$1.95

Dual Module Bay Adapter

BAM-02117
The Dual Module Bay Adapter is designed to be mounted on a traditional bay sled and supply mounting for all of SMT Designs' device and battery carriers, as well as all normal length hybrid platforms.
$3.95

Quad Module Bay Adapter

BAM-04117
The Quad Module Bay Adapter is designed to be mounted on a traditional bay sled and supply mounting for all of SMT Designs' device and battery carriers, as well as all normal length hybrid platforms.
$5.95

Platform Brackets

SBR-00113
The Platform Brackets were designed to make the use of SMT Designs platforms in a traditional electronics bay easier.
$2.45

Bay 9 Volt Battery Holder Kit

BH9V-00112
The bay battery holder secures a 9 volt battery on a traditional electronics bay sled and allows for the battery leads to be positioned in any of the four corners of the holder.
$3.45

2 Post Feedthru Kit

DF2P-00104
The 2 post feedthru supplies an insulated part so wiring can transition from inside an electronics bay to the outside for connection to igniters, electric matches, or other electronics.
$2.45

4 Post Feedthru Kit

DF4P-00105
The 4 post feedthru supplies an insulated connection from the internal electronics bay to the outside for igniters, electric matches, or other electronics.
$3.45

Low Profile Switch Kit

LPS-00115
The low profile switch was designed to be part of a traditional electronic bay to arm and disarm device using an arming screw through the outside wall of a rocket.
$3.45

Bay Switch Kit

SWBY-00109
The bay switch kit was designed to be part of a traditional electronic bay to arm and disarm a device using an arming screw through the outside wall of a rocket.
$3.45

Tie Wrap Loops Kit

TWL-00162
The tie wrap loops are used in traditional electronic bays to organize and support wiring on your sled.
$2.45

4 Terminal Through Mount Connector Block Kit

CB4TM-00106
The 4 terminal connector block kit is designed to be used inside of a more traditional electronics bay.
$2.45

4 Terminal Tab Mount Connector Block Kit

CB4EM-00107
The 4 terminal tab mount connector block kit is designed to be used inside of a more traditional electronics bay.
$2.45